Forklift blades spacing must be properly adjusted in order to prevent panel damages and for a balanced transportation by forklift.
Fabric slings must be used to unload panels, and the slings should be suspended on crane hook using a steel apparatus.
Panels should be carried in vertical position in order to prevent bending. It should only be held from the single layer plate female connection edge.
If you need to cut the panels, use decoupage or special cutting tools instead of spiral grinder.
Protective film coating used in panel production must be removed latest in two weeks. Longer periods may cause damages on paint layer during removal.
Pads must be placed under piles awaiting for assembly at minimum 150 cm intervals. Piles should not be in inclined position on pads. Storage of panels in piles over 4 weeks is not recommended. Maximum 2 piles can be placed. Panels should be stored in an indoor area. Panels should be protected against direct sun light, snow and rain exposure. A natural ventilation should be allowed under cover in order to prevent sweating. Panels should be protected against corrosion by water and moisture accumulation between panels.
Warning: It is customer responsibility to ensure fire safety both in stock and during and after assembly.